• If your internet access is still not available, contact TP-Link Technical Support. Q2. How do I restore the router to its factory default settings? With the router powered on, press and hold the Reset button until the LED blinks and then release the button. Note: You’ll need to reconfigure the router to surf the internet once the router
Have SSID and Wireless Password ready.They are printed on the internal side of the back cover. (For M5360, they are printed in the label attached to external part of the back cover).
Plug your extender into a power outlet (note that the extender must be next to your router). Wait till the power LED turns solid on. Press the WPS button on your router. Push the WPS switch on your extender and hold it for 1 second. ( in this step, the LED should change from blinking to solid. Step 2: Log into your router. The default password is “admin”. Step 3: Check your firmware. Click Advanced – System Tools – Firmware Upgrade. Step 4: Upgrade to the HomeCare is supported on ‘Build 20170504’ or later. Step 5: Once you are on a compatible firmware, you will need to log back into your router.In the beginning, when the router is on, turn it to the backside to access rear connectors and buttons. Aftert that, find Reset Button and press it with a pencil or something thin. Hold it for over 10 seconds. All Archer A6 LED lights should flash a few times. Finally, give TP-LINK router a minute or two to reboot and restore its normal
1. Make certain that the router is powered on before it restarts completely. 2. The default IP address is 192.168.0.1(or http://tplinkwifi.net ), and the default login username and password both are admin (all lower case). 3. Ensure that the IP address of your computer is in the same subnet as the device. .